ECS BAT-I2 board firmware, revision V1.0, packed as a 3.02 MB RAR archive. The name gives no chip type, BIOS version or tested status, so open the archive and check the image size against the SPI flash fitted on the board before doing anything else. ECS prints the model and revision on the PCB silkscreen, and that marking should match BAT-I2 V1.0. Read and save the original chip contents with a programmer such as a CH341A first. Then write this image and verify it, which gives you a way back if the board will not start.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosarchive. Enginerys does not host this file.
All sources (11)
The same file was posted more than once. If one link is dead, try the next.
| Channel | Posted | |
|---|---|---|
| @biosarchive | 23 Sept 2023 | Open file on RM Schematics |
| @generalbios | 4 Oct 2023 | Open file on RM Schematics |
| @generalbios | 6 Oct 2023 | Open file on RM Schematics |
| @generalbios | 8 Oct 2023 | Open file on RM Schematics |
| @generalbios | 9 Oct 2023 | Open file on RM Schematics |
| @generalbios | 13 Oct 2023 | Open file on RM Schematics |
| @generalbios | 15 Oct 2023 | Open file on RM Schematics |
| @generalbios | 19 Oct 2023 | Open file on RM Schematics |
| @generalbios | 26 Oct 2023 | Open file on RM Schematics |
| @generalbios | 29 Oct 2023 | Open file on RM Schematics |
| @generalbios | 26 Nov 2023 | Open file on RM Schematics |
How to open a .rar file
Compressed archive — the usual wrapper for a schematic + boardview pair or a BIOS + EC set.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →