Small two-byte file recording the status register of a GigaDevice GD25LQ128 flash, saved during a read on 18 December 2018. No device or board is named. The LQ series are 1.8 V parts, so a 3.3 V programmer setup needs a suitable 1.8 V adapter or the chip can be damaged. The file itself has no firmware; it stores protection and configuration bits that some programmers save beside the 16 MB image. Use it with the matching dump, and check the chip voltage on its datasheet before connecting any clip or socket.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosfilebins. Enginerys does not host this file.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →