Status register value saved as a tiny two-byte file from a GigaDevice GD25Q64 chip read on 9 October 2019. The device and board are not named. It is created by programmer software alongside an 8 MB chip read and records write-protect and configuration bits rather than firmware. Restoring these bits matters when the original chip had specific protection set. On its own the file is of little use; pair it with the same-timestamp dump, and confirm the status register after programming so later BIOS updates are not blocked.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosfilebins. Enginerys does not host this file.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →