Firmware dump for the LG Flatron W1942ST monitor, main board marked W1942S-PF, read from a W25X20 SPI flash chip, a small 2 Mbit Winbond part. Monitor firmware of this kind controls the scaler, so a corrupted chip often causes no picture, a stuck logo or a dead power button. Write the image back with an SPI programmer after saving the original contents. Check that the chip on your board is the same type and capacity, and that the main board marking matches.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosarchive. Enginerys does not host this file.
How to open a .rar file
Compressed archive — the usual wrapper for a schematic + boardview pair or a BIOS + EC set.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →