EDID content for the LG LP101WH1 laptop panel, marked revision TL A3, saved as a 256-byte .bin. A display uses this block to tell the host its identity, timing parameters and preferred resolution over DDC. Writing a clean copy back is the usual fix when the panel is not recognised, flickers at startup or runs in a fallback mode after an EEPROM corruption. Use an I2C programmer or a dedicated EDID tool, verify after writing, and make sure the replacement panel carries the same LP101WH1 TL A3 marking.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosarchive. Enginerys does not host this file.
All sources (7)
The same file was posted more than once. If one link is dead, try the next.
| Channel | Posted | |
|---|---|---|
| @biosarchive | 26 Mar 2019 | Open file on RM Schematics |
| @biosarchive | 1 Oct 2020 | Open file on RM Schematics |
| @pepeelectronica | 20 Apr 2022 | Open file on RM Schematics |
| @pepeelectronica | 26 Apr 2022 | Open file on RM Schematics |
| @schematics_bios | 23 Jul 2026 | Open file on RM Schematics |
| @schematics_bios | 25 Jul 2026 | Open file on RM Schematics |
| @schematics_bios | 2 Aug 2026 | Open file on RM Schematics |
How to open a .bin file
A raw, byte-for-byte image of a flash chip: the main BIOS / UEFI, the embedded-controller (EC) firmware, or both.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →