EDID backup for LG LP156WH2 15.6-inch panel with the TL E1 revision, saved as a 256-byte binary. It is meant for rewriting the panel serial EEPROM when the display is not recognised, shows the wrong native mode or causes a black screen at boot. Writing is done over I2C, either through the panel cable with suitable software or directly with a CH341-type programmer. Make sure the panel sticker reads LP156WH2 TL E1, store a copy of the original EEPROM and verify after flashing.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosarchive. Enginerys does not host this file.
How to open a .bin file
A raw, byte-for-byte image of a flash chip: the main BIOS / UEFI, the embedded-controller (EC) firmware, or both.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →