EDID dump for an LP140WH1-TLA1 laptop LCD panel, labelled for the Packard Bell NJ65 notebook. At 256 bytes it holds the panel identification block that the system reads over the DDC lines to learn native resolution, timings and vendor data. Technicians write such an image into the small EEPROM on the panel or the eDP/LVDS board when the original data is corrupted and the screen stays black or shows a wrong resolution. Confirm the panel part number on the rear label matches and save the existing contents before programming.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosarchive. Enginerys does not host this file.
All sources (3)
The same file was posted more than once. If one link is dead, try the next.
| Channel | Posted | |
|---|---|---|
| @biosarchive | 26 Mar 2019 | Open file on RM Schematics |
| @biosarchive | 1 Oct 2020 | Open file on RM Schematics |
| @ITHINKHS | 8 Oct 2020 | Open file on RM Schematics |
How to open a .bin file
A raw, byte-for-byte image of a flash chip: the main BIOS / UEFI, the embedded-controller (EC) firmware, or both.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →