Firmware read from an HP G6-1330se laptop, 4 MB binary, apparently taken directly from the chip given the read prefix in its name. A dump obtained this way usually represents a full chip image and can serve as a donor for another unit of the same model. Program it with an SPI programmer after backing up the target chip, and confirm that chip capacity is 4 MB. Check the motherboard number on the PCB, since the same HP model line was built on different boards.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosarchive. Enginerys does not host this file.
How to open a .bin file
A raw, byte-for-byte image of a flash chip: the main BIOS / UEFI, the embedded-controller (EC) firmware, or both.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →