MediaStar SR-2023HD satellite receiver software in version V3.95, dated 26 October 2026, stored as a 3.13 MB .bin. Such a full image allows a repair technician to recover a receiver that is stuck in a boot loop or shows only a frozen display, either via the vendor loader or by direct SPI programming. Model numbers in this range are close, so check the unit really is an SR-2023HD and not an SR-2022HD, and keep a backup read of the chip before flashing.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @tvsoftwareworld. Enginerys does not host this file.
How to open a .bin file
A raw, byte-for-byte image of a flash chip: the main BIOS / UEFI, the embedded-controller (EC) firmware, or both.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →