Firmware dump for the TP-Link TD-W8901G ADSL router, hardware version 6.0, read from an EN25QH16 flash chip, which is a 16 Mbit (2 MB) SPI device. Packed in a 2.69 MB RAR archive, it is used to revive a router bricked by a bad firmware update or stuck in a boot loop by writing the image directly to the chip with a programmer. Check that your unit is hardware version 6.0, back up the existing flash contents, and note that MAC address and calibration data may differ between units.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @biosarchive. Enginerys does not host this file.
How to open a .rar file
Compressed archive — the usual wrapper for a schematic + boardview pair or a BIOS + EC set.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →