SPI flash image for the Haier LE32B3000D television, taken from a mainboard marked MS33931-ZC01-01, with the memory chip named as an MX25L3206E. The file is a 4.00 MB raw binary, which matches the 32 Mbit capacity of that Macronix part. It is used to repair firmware corruption that shows up as no picture, a stuck logo or a dead standby LED. Check that the PCB code matches, back up the existing chip, then write the image with a programmer that supports the MX25L series and verify it afterwards.
The button opens the matching file on RM Schematics, or a source page if it is not catalogued there yet. The original attachment is from @hashmielecom. Enginerys does not host this file.
How to open a .bin file
A raw, byte-for-byte image of a flash chip: the main BIOS / UEFI, the embedded-controller (EC) firmware, or both.
Back up your own chip before writing any dump, and match the full board number and revision. Flashing guide →